CAN sensors / modules

Connect CAN sensors to any CAN port CN1 or CN2 on the monitoring system using a CAN FTP cable supplied. CAN sensors can also be connected to the port of another CAN sensor or CAN module which are connected on the CAN bus. Determination of the module and its connection is done through web-interface.

This procedure applies to the following sensors, which are supported by the appliance and are connected to the CAN ports:

CAN-Sensoren:

  • Rauch, Temperatur- und Feuchtigkeitssensor
  • PIR-, Temperatur- und Vibrationssensor


CAN-Module:

  • Air flow and temperature monitoring unit
  • Sensor unit 

Connection of Didactum PIR, vibration and temperature sensor

Connecting other CAN sensors and units